When Lowriding Goes Horribly Wrong... Fail Compilation!

Posted by: Jesse Kleib on 11/17/2021

Sure, in the world of racing, vehicle components obviously are going to take more than their fair share of a beating. When you’re out there trying to shave tenths of seconds off of your best time, putting more and more of a load on the components at hand, well, eventually, you’re going to find their limits. This can result in some pretty expensive situations as you grenade various parts that might just cost thousands of dollars, however, the world of racing isn’t the only place where high dollar components are put to the test and eventually end up being replaced by something bigger and stronger.

As it turns out, the world of low riders can be just as aggressive. It might not seem like a community that really puts a lot of tension on the parts underneath of their vehicles, however, when you consider these things are banged up against surfaces that are a little bit too high for the ride height and even more aggressively are used in competitions where they bounce to the moon, supporting the weight of the car as it bangs down hard in these adverse conditions can really be something that takes a toll on anything that is used to support weight or provide structure. Therefore, in the long run, you end up seeing some pretty interesting part failures.

If you follow along down in the video below, you got a whole collection of these lowrider vehicles going hard and ending up with a result that isn’t exactly the most desirable in the world. The long story short here is probably that if you’re near one of these things as it is putting on a show, you might want to keep a watchful eye out and maybe keep your distance because you never know when a spring is going to shoot out from underneath and come flying towards you! It certainly provides a lot of interesting situations, so be sure to see them here!

0 comments